Casella CEL Software for Nomad (User Configuration) - Manual (Page 4)

Monitor
System
Method of
Connection
Method for
Configuration
Download
Data
Data from any PC
with shared
monitor system
files
Network $ Download to Online Pro from
station output files
X
Wind Speed and
Direction Sensors
Direct (via RS 232) Implicit when connected X
Particle Counter Direct (via RS 232) Implicit when connected X
Multimet Direct (via RS 232) Implicit when connected √
Sensus % Data
Logger (i.e.
Nomad Etc.)
Direct (via RS 232) Upload from Online Pro
Download to Online Pro
√
Modem &
GSM Modem
Upload from Online Pro
Download to Online Pro
√
Low Power Radio
Modem
(Wood & Douglas)
Must be defined in Online Pro X
High Power Radio
Modem (Warwick)
Upload from Online Pro
Download to Online Pro
√
Demonstration
(without hardware)
File Implicit when connected X
CEL-440/480
SLMs
440/480 Implicit when connected X
When new software is supplied for use with an existing
measurement arrangement, Online Pro may be able to interrogate a monitor
system that has already been configured, and download it’s configuration and
setups without the need to re-enter data. When software must to be
re-configured after a measurement arrangement has been changed (for
example if additional sensors or monitor systems have been added), the
configuration and setups can be edited and then uploaded to the
measurement arrangement.
Refer to Section 6.1 for instructions on defining a monitor system,
Section 6.2 to interrogate a system for its configuration, Sections 6.3 and 6.4
to configure a system, Section 6.5 to edit the configuration saved on a
Sensus Data Logger, Section 6.6 to send a configuration to the system and
Chapter 3 for details of setting up page and channel information.
6.1 Defining / Deleting a Monitor System
This allows monitor systems to be added to or deleted from your
arrangement. Each monitor system must be defined (added to) the
Note 6: Online Pro cannot be used to configure a monitor system connected via a
network. The software must interrogate the system and download the
configuration from the monitor system’s network output file.
Note 7: When the monitor system is connected via a Sensus Data Logger, an
Additional Sensus Data Logger configuration is stored by the
Logger. This configuration can be accessed and edited by Online Pro and
specifies parameters to be measured, channels to be used, alarm settings
and communication details that are to be used by the Sensus Logger itself.
Configuration
Page 38 of 68
ONLINE Pro Application Software for
Automatic Monitor Systems - Users Handbook