CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 22)

8. Designing new Tags
This part of the program allows you to design own tags and elements or labels.
In order to open the program, choose > Extras and > Elements from the main menu.
To open the designer for labels for the endless
TT-Printer and Office Printer choose > Extras and
> Labels from the main menu.
There are two versions available designing new tags:
Design tags with same size
Design tags with different sizes
If you like to design e.g. a label sheet with same sized labels in a matrix, use
> Design tags with same size. If you like to design e.g. a serial no. plate with different
sized label areas, use > Design tags with different sizes.
Note: Designing tags is only possible with a plotter as output device selected. If you
are working with the engraving feature, the software
suggests to use either the half (DIN A4) or full size
(DIN A3) plotter.
The use of the design program is described below,
after saving, the designed elements are available for
labeling in the folder > User defined under > Producer
(manufacturer) after selecting the correct output
device.
21