CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 35)

Various engraving options could be set in the middle part of the window:
Only one engraving tool and depth to be used
In order to execute this job, two or more
engraving needles to be used might be indi-
cated. If you like to use one needle size and
penetration depth only, please check this box.
Only one engraving speed to be used
In order to execute this job, different engraving
speeds (2 to 20 mm per second) could be
selected from the data entry. In order to work
with one speed selection only, please check
this box and select the respective engraving
speed.
Only one revolution speed (RPM) to be used
In order to execute this job, different revolution speeds (5000 to 50000 RPM) for the
engraving spindle could be selected from the data entry. In order to work with one
selection only, please check this box and select the respective revolution speed.
Only one penetration speed to be used
In order to execute this job, different penetration speeds (0.5 mm to 5 mm per second)
for the engraving needle could be selected from the data entry. In order to work with
one selection only, please check this box and select the respective penetration speed.
All selected tags will be engraved
If you check this box, only the tags marked before are subject to be engraved.
Select a sequence
Just click in the edit window on the sequence once and it is marked.
Select multiple sequences
Just click in the edit window on the first sequence once, hold down the
Shift Button and click on the next sequence ones etc. and all are marked.
Select single tags
Hold down the Control Button and just click in the edit window on the single
tag or multiple tags once and they are marked.
All selected segments will be engraved
If you check this box, only the segments marked before are subject to be engraved.
Just click in the edit window on the segment once and it is marked. In order to mark
two or more segments, hold down the Control Button and click on each segment
once.
34