CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 25)

Please follow the steps for taking measurements:
Determine the exact position of the
first tag on the label sheet. In order to
do so, please click on the most left
button Initial position of the window.
The arm of the plotter moves to its upper left corner limit (zero position). From there
you can move the arm with the pen inserted to the upper left corner of the first tag with
the cursor buttons. You can select the size per step in mm in the upper right area of
the window.
Please check with the Pen Up/Down button the correct position after you moved the
pen to the initial point of the tag. The respective co-ordinates are shown in real nos. in
the x- and y- window based on the zero position.
Determine now the exact position
at the lower right corner of the first
tag. Just repeat the steps as for the
upper left corner, described above.
As next step, determine now the
exact position of the upper left corner
of the last tag (size of matrix).
Take the initial position in the same
manner as described above.
After completion of the three steps all measurements are taken for the element.
In order to save the data for the new element, please click on Accept.
The window "Take corner measurements of tags" will be closed and you are back to
the previous window.
24