CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 23)

8.1 Example for designing a label sheet (matrix) with same sized labels for plot-
ting and engraving
Open the designer from the main menu with > Extras > Elements
> Design tags with same size as described above.
The following window appears:
With a click on the button New a new element can be named in the window under
<Untitled>. It is useful to work with the element recognition system of the plotter in
order to find the element more easy later on.
For the element you want to design, enter a
new name in the window <Untitled>.
If you don´t want to use the element
recognition system or you are working offline
(without being connected to the EMS-2),
select the type of support plate for the sheet.
You can select between a quarter size, half
size or full size support plate.
You can always assign the support plate to
the project later on. As soon as you are connected back to the plotter place
the support plate and click on the button Assign support plate identification.
Pre-selected is the plate for sheets (half size plate).
Further you can select in the lower left part of the window, if the new designed material
is for plotting only or plotting and engraving. The buttons are only active once the
support plate is recognized or assigned to the project.
Once selected, click on the Edit button.
Note: Engraving is only possible on dedicated support plates.
22