CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 24)

A new window opens up,
where you can enter the data
of the tag (size of the label),
if known.
You can always take the
measurements using the
plotter system, if the data is
not available.
You need only to enter the
nos. of tags in x and y
direction.
All other data necessary for the program, can be taken with the plotter system.
Please enter the no. of tags in x and y direction as shown in the window.
If available enter also the size of the tag (label) and the distance to the next tag. You
can always correct the data later on, if the exact nos. are not present at the moment.
Always take the start position of the first tag with the plotter system!
Further on, you can decide on the labeling direction of the tags.
For the sequence for plotting or engraving you can choose between upper left to upper
right (by row) or upper left and lower left (by column).
Attention: It is essential for continuing the design to switch on the plotter and have the
support plate with the label sheet placed on.
Insert a plotter pen directly into the pen holder of the plotter.
If you have entered minimum the no. tags (label) in each direction, please click on the
Take measurements button.
A new window opens up, providing
buttons and entry windows, in order
to take all relevant measurements
for the new element.
23