CONTA-CLIP CONTA-Sign 4.3 User Manual
Page 38
10. Calibrating the Plotter
The EMS-2 is calibrated during the production. In case of small deviations, like the
printout is not correctly in the center of the marker, the plotter could be calibrated
manually.
In order to do so, please make sure there are no parts on the plot field, like ball
pen, not proper mounted support plates etc., then go to the
menu > Output > Output device and choose > Calibration.
The arm moves into the center position.
In the window on the screen you have 4 cursor buttons in order to move the setting in
either direction, in steps .025 mm up to 10 mm, the default setting is .1 mm.
Each click in the button will move the Pen holder
connected to the arm into the desired direction. After
the changes made, hit the C
C
C
Ca
a
a
alllliiiib
b
b
brrrra
a
a
atttte
e
e
e button and the
new settings are stored in the software.
Please check again during the next print, if necessary
use the calibration function again until the output
performance is satisfied.
Use always the first tag at the upper left corner of the
segment (see also item 7 Scale factor).
The R
R
R
Re
e
e
ess
s
se
e
e
etttt button takes you back to the original set-
ting.
Although the other output devices you might want to use are pre-calibrated, because
of the different starting point, the calibration procedure as described is essential with
those other devices.
37