CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 36)

Various options for the frame are available in the lower part of the window:
Reverse labeling
With this option selected, the lettering will be reverse engraved. You will have a clean
surface at the front, engraved from the back side. Useful for engraving letterings used
in harsh environments, no particle could stick
in the engraved groves making the lettering
unreadable (specific material required).
Engrave frame around lettering
With this option selected, a frame will be
engraved around the lettering. First the
lettering will be engraved. Thereafter the
engraving process stops asking you in a
message box to change the engraving needle
or to alter the engraving depth.
If no tag is selected, all frames around the
tags will be engraved, even if they don’t carry
any lettering.
Engrave frame only
With this option selected, the frame will be engraved only without the lettering.
This selection is useful engraving multiple depths on thicker material. Using first a
lower penetration depth and for the second run the final setting.
Round frame corners
With this option selected, you can select in a combo box various
radius settings for the corner engraving of the frame. Possible settings for the radius
are between 1 mm and 5 mm in .5 mm steps.
35