CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 37)

The engraving job starts with a click on the OK Button.
The software checks again if the selected support plates are placed on the plotter.
If not, a warning message comes up to be
confirmed, either continue or cancel.
There after the software reminds you by a
message to verify, if the selected engraving needle is inserted into the spindle.
This message needs to be confirmed with a click on the
OK Button and the engraving job starts.
In case the already started engraving job should be stopped, please click on the
icon Stop Plot in the menu bar. The engraving will be interrupted, the data
(if any left) in the print spooler of the PC and the EMS-2 Engraver will be deleted.
The EMS-2 Engraver will move back to the origin, waiting for the new job.
Alternative the power of the EMS-2 can be re-cycled by pressing the OFF and ON
button. All existing data will be deleted and the zero position re-aligned.
For further information, please refer to the operating instructions of the
Plotter EMS-2.
36