CONTA-CLIP CONTA-Sign 4.3 - Manual (Page 33)

Following adjustments for the engraving unit could be made and selected from.
Size of tool
Engraving needle in the size of .2 mm up
to 1 mm could be selected from.
Engraving speed
Adjustments of 2 mm/s up to 20 mm/s
could be selected from
Revolution per minute (RPM)
Adjustments of 5,000 up to 50,000 RPM
for the engraving spindle could be selec-
ted from
Penetration speed
Adjustments of 0.1 mm/s up to 1 mm/s could be selected from in steps of .1 mm/s
The type of the tool and the penetration depth will be suggested according to the
selected engraving material.
Restore Default values:
If you change the above parameters for each element the data will be stored in a
separate file. If you choose the element again, you will find the previously used
parameter settings.
Click Default values , if you want to restore the original settings.
Note: After updating the software the user´s specific parameters remain valid.
32