Televes Serie H-60 - Manual (Page 34)

34
Measures Config.
3.3.1.2.4.- Motor Control
The H60 Advance makes it possible to control the DiSEqC motors used to move mobile
parabolic antennas. This function is available in satellite mode and when the equipment is
powering the LNB.
If it is not in the satellite band, the message “ Satellite Only ” will be shown, and if there is no
power the message " No DiSEqc. Vdc off " will be shown.
- Motor Control -
EAST: Allows the motor to move in the EAST direction. Each click corresponds to one step in
the movement of the motor (pitch motors). By holding the key down, successive
movement sequences will be executed until the key is released.
WEST: Motor movement in the WEST direction. Each click corresponds to one step in the
movement of the motor (pitch motors). By holding the key down, successive movement
sequences will be executed until the key is released.
STOP: This command stops the motor movement.
IDLE: Puts the motor in the reference position. This position will depend on the type of motor
(normally 0º).
POSITIONS: 4 storage positions are available to store at up to 4 antenna positions.
- RECORD: allows one of 4 positions to be chosen (A, B, C or D) where the current position
of the antenna will be stored.
- RECOVER: recovers one of the four positions (A, B, C or D) for the antenna that has been
previously stored.
01031052_002_EN:103130_00.qxd 10/07/2013 8:00 Página 34