Televes Serie H-60 - Manual (Page 9)

9
EN
To restart the process, press the same key again. Charging will also restart if external powering
is disconnected and reconnected or if the equipment is turned off.
The equipment carries out a continuous monitoring of battery status informing the user of the
battery charge through an icon, a LED (
Battery ) and a sound signal.
The icon shows 5 stages, approximately representing the battery charge:
=> Battery charge less than 5%. Empty icon, blinking red at bottom (if not outer
power is connected) and low battery sound alarm.
=> Battery charge more than 5% and less than 25%
=> Battery charge more than 25% and less than 50%
=> Battery charge more than 50% and less than 75%
=> Battery charge more than 75%.
The LED reports on battery status during the charging process. This LED’s blinking time will be
a function of the battery charge level.
While the charge level is under 25%, the LED will be on for 500 msec and off for 2.5 sec. As it
charges, the on time will go increasing and the off time diminishing. When the charge reaches
75%, the LED will stay on for 2.5 sec and off for 500 msec. When it is completely charged, the
LED will remain permanently on while the equipment is in use.
If the battery charge drops below 5%, the icon filling will appear in red, and the equipment
will begin to beep and show a low battery message on the display.
If the discharging process continues, the equipment will issue warnings every 10 seconds that
it is turning off, and if external powering is not connected before 30 seconds go by, it will finally
turn off.
The charging process, starting from a completely discharged battery, will last for 8 hours.
With a charging time of 3 hours, the battery will be 75% charged.
When the battery is totally charged, the inside of the icon is completely orange. As
the battery goes discharging, the orange filling reduces, leaving the battery empty
(transparent).
01031052_002_EN:103130_00.qxd 10/07/2013 7:59 Página 9