Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 29)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 29
RmcpGuid
RMCP group user id
16 hex bytes [01 02 03 04 05 06 07
08 09 10 11 12 13 14 15
16]
- default guid
All zeros(16
bytes)
RmcpUser[X]
X is an integer
Ex: RmcpUser2, RmcpUser3,
RmcpUser4 etc
RMCP users
<U><P><Pr><MS><A
>
U - username
P - Password
Pr - Privilege
MS - Maximum
number of
sessions
A -
Authentication
[RmcpUser[2,3,4,5,6]]
are available in config file
Ex:
RmcpUser6 =
"Administrator
Administrator admin 64
none md2 md5 straight"
NA
SelMaxEntries
Maximum number of
entries in the SEL
<0…N> [240] 1024
SelCleanPolicy
Policy to retain/remove
the SEL entries once
maximum is reached
“true | false” [false]
- Will not add the
SEL entries to the SEL,
once the SEL is full
true
- Removes the oldest
sel entry when the entries
reaches the SelMaxEntries
false
Script<old_state>
<new_state>
Ex:
ScriptInitializeAloneScr
iptInitializeActive
etc
State change script that
gets executed when the
HPI state changes from
old_state to new_state.
This script is responsible
for setting virtual active
IPs in response to the
state change
“/opt/bladeservi
ces/etc/bbshpib/
StateChange”
[/opt/bladeservices/et
c/bbs-
hpib/StateChange] /opt/bladese
rvices/etc/b
bs-
hpib/StateCh
ange
FumiEnabled
Enabling FUMI plugin
Note: All the following
FUMI related tags are
not applicable when
FumiEnabled is set to
false
"true | false" [true]
- Load the FUMI plugin,
supported on ATCAM100/
ATCA-MF105
false
- FUMI plugin is not
supported for this ATCAboard
true
FumiTimeout
FUMI timeout
<100..900000> [300000]
- 300 ms
300 ms
FumiRemoveLocalImageAfte
rUpgrade
Remove/Retain local
image after upgrade
"yes | no | true
| false | on |
off" [<true|on|yes>]
- remove
image after upgrade
<false|off|no>
- preserve
local image after upgrade
Default value is true
true
FumiPreserveOemRecords
Preserve/Don't
preserve OEM records
after upgrade
"yes | no | true
| false | on |
off" [<true|on|yes>]
- do not
preserve
<false|off|no> - preserve
Default value is true
true
Table 2-5 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default