Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 31)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 31
2.3.1 Installing HPI Clients
Procedure
In order to install an HPI-B client package on a node blade, proceed as follows.
1. Connect to the node blade where you wish to install the HPI-B package.
2. Copy the RPM file that you wish to install to the node blade. Refer to Table "RPM Files
for HPI-B Clients" on page 21 for details on available RPM files for your particular
node blade.
3. If applicable, enter rpm -e <Old HPI-B client package name> to uninstall
an already installed client package.
4. Enter rpm -i <New HPI-B client RPM file name>
This installs the HPI-B library package.
The following table lists the directories and their content available on the blade after installing
the package.
2.3.2 Configuring HPI Clients
Before running your client, you need to configure the multishelf library:
/opt/bladeservices/etc/bbs-hpib/bbs-hpibmultishelf.conf
Table 2-6 Overview of HPI-B Directories and Files on Node Blades
Directory Description
/opt/bladeservices/l
ib
Contains example applications and shared libraries needed to run
clients
/opt/bladeservices/b
in
Contains precompiled example applications. They are controlled
via the command line and can easily be identified through the
prefix "hpi" in their names. Use the -h option to display supported
command line parameters.
/opt/bladeservices/b
bs-hpib
Contains configuration files used to configure HPI client libraries.
See
Configuring HPI Clients on page 31 for details.