Table 4-49, Configurable sol parameters, Using hpi-b – Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) User Manual
Page 85
Using HPI-B
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide
85
LAN channel IP address = <shelf IP address> +<LAN channel> * <configurable multiplier> +
0.0.0.<10*logical slot> + <configurable offset>
Example:
Shelf IP address = 172.16.3.0
logical slot = 14
LAN channel = 1
configurable offset = 0.0.100.0
172.16. 3. 0
+ 0. 1. 0. 0
+ 0. 0. 0.140
+ 0. 0.100. 0
---------------------------
LAN channel IP address = 172.17.103.140
Most of the other parameters used during SOL configuration can be configured in the HPI
configuration file /etc/bbs-hpib/bbs-hpibd.conf on the ATCA-M100/ATCA-
MF105/SAM-1410. Entries to the configuration file are optional. If for a parameter there is no
entry in the configuration file, a built-in default value is used. The following table gives details
on all configurable parameters:
Table 4-49 Configurable SOL Parameters
Keyword
Description
Allowed
Values
Default in
Config. File
Built-in
Default
Sol_MgmtEnable
1: enables SOL
configuration
0: disables SOL
configuration
0, 1
1
enabled
Sol_UserId
User ID used for SOL
2-4
2
Sol_UserName
User name used for
SOL
String of
length 1-16
soluser
name
Admini
strator
Sol_Password
Password used for
the SOL user
String of
length 1-20
soluserpassword Admini
strator