Burst Electronics LG-1 - Manual (Page 22)

numeric value from 0 – 99. 0 places the logo to the far
left, and 99 places the logo to the far right.
Vert Posn - a pop-up window prompting for a numeric
value from 0 – 99. 0 places the logo at the top of the
video, and 99 places the logo at the bottom of the
video.
Send Logo – downloads a logo to the LG RAM.
Save Settings to EEPROM – saves the position,
brightness, mix ratio, and fade rate to the LG NVRAM.
Save Logo to EEPROM – downloads a logo from the
LG RAM to the LG NVRAM (perform this step after a
logo has been sent to the LG RAM).
Blink Test – causes the Active LED on the LG
hardware’s front panel to blink three (3) times.
Set Time ON - a pop-up window prompting for a
numeric value from 15 seconds – 3825 seconds (3825
seconds = 1hr 3min 45sec). This value is the length of
time a logo will be displayed.
Set Time OFF - a pop-up window prompting for a
numeric value from 15 seconds – 3825 seconds (3825
seconds = 1hr 3min 45sec). This value is the length of
time a logo will not be displayed.
Wakeup LG – forces LOGOGEN to send the
command to wake up a LG (LOGOGEN automatically
sends this command every 15 seconds unless the
Sleep All Nodes command is sent.
Sleep All Nodes – causes the LG hardware to stop
responding to LOGOGEN. Use Wakeup Node to
continue communicating to a LG.
Retrieve Settings – forces LOGOGEN to retrieve
from a LG, position, brightness level, mix ratio, fade
speed, and On/Off settings.
Select Logo – a pop-up window prompting for a
numeric value from 1 – 4 (LG-4 only).
Retrieve Logo – This function allows a user to save a
stored logo from the LG hardware. Cycle through the
stored logos in the LG hardware to find the logo that is
LG-1+ and LG-4 Logo Generators 21