Burst Electronics LG-1 - Manual (Page 28)

the switch down causes the logo to be more
transparent.
Speed – Adjusts the rate at which a logo will transition
between on and off when a Take function is
performed. Pulling the switch up will cause a faster
transition, pushing the switch down will cause a slower
transition. The range of speed is from 0.05 seconds to
just under 5 seconds.
Level – Adjusts the brightness level of a logo. Pulling
the switch up causes the logo to be brighter, pushing
the switch down causes the logo to darker. The range
of brightness is 100IRE (full brightness white) to
7.5IRE (full black, 0 IRE if PAL).
- The up/down arrow switch is used to change the
logo position vertically.
- The left/right arrow switch is used to change the
logo position horizontally.
Take – This switch has three functions, the first
function is a toggle between a logo being displayed
and not being displayed. Pull the switch up to
accomplish this toggle. The second function is to force
the LG into a Schedule Cycle (see Control Panel –
On/Cycle for information on setting up these times).
Push the switch down (the switch stays down) to start
the internal counter for controlling a scheduled take.
The third function is a Save Settings function (see File
Menu – Save Current Setting in LG NVRAM). To
operate this function, pull up on both the Take switch
and the Up/Down switch simultaneously.
Active – This is a LED that indicates if a logo is
currently being displayed (LED on and the logo is
LG-1+ and LG-4 Logo Generators 27