Lynx Studio Hilo Reference A/D D/A Converter System - Owner's Manual with LT-USB User Manual
Page 22
Page 18
To change the meter type, tap the meters on the screen, and the Meter Type menu will appear:
Touch on the type of meter you would like to see. The new meter will instantly appear. If no selection is made, clicking
anywhere on the Touch Screen outside of the menu will cause the menu to close.
3.2.1 Choosing the Meter Source
You can select any Input or Output Source to be shown on the Analog VU and Horizontal Meters.
3.2.1.1 For the Analog VU Meters:
Touch the Monitor Source Selection button that is centered at the bottom of the screen. Before touching the button, it
will show the current selection. A Pop-up will appear with two sets of input sources on the left and six sets of output
sources on the right.
Tap on the input or output source you need. The meter will reset and the Pop-up will close. The Monitor Source
Selection button now shows your new selection. The Pop-up will remain on the screen until you either make a
selection, or tap outside of the menu in order to close it.