Lynx Studio Hilo Reference A/D D/A Converter System - Owner's Manual with LT-USB - Manual (Page 23)

Page 19
3.2.1.2 For the Horizontal Meters:
This is the same process, but you can select different sources for each meter pair.
Touch the Monitor Source Selection button that is centered at the top of the screen for the upper meter set or the
Monitor Source Selection button that is centered at the bottom of the screen for the lower meter set. Before the buttons
are pushed, they will show the current meter selection. A Pop-up will appear with two sets of input sources on the left
and six sets of output sources on the right. These are the same options as for the Analog VU meters. Tap on the input or
output source you need. The meter will reset and the Pop-up will close.
Use the same procedure for the other meter set. . The Pop-up will remain on the screen until you either make a
selection, or tap outside of the menu in order to close it.
3.2.1.3 For the All I/O Meters
With the All I/O meter page, no selection is needed as all input and output sources are shown. The All I/O page is
useful for different reasons. When setting up your routing (explained later) this page gives you a global view of what
input channels are active and which outputs are receiving audio from at least one source.