Lynx Studio Hilo Reference A/D D/A Converter System - Owner's Manual with LT-USB - Manual (Page 50)

Page 46
3.7.2 Return to Meters
Hilo will revert to the Meters screen after some period of inactivity. The default period is 15 seconds. This is where
you can change that delay time.
• Shows the current Menu Delay
• This sets the time that any menu, selection page, pop up menu or
status page will stay active before the screen defaults back to the
selected Meter page. The only menu page that does not “time out” is
the Output Mix Routing Page.
• Pushing the button engages a horizontal fader that lets you set the
delay to 15 seconds, 30 seconds, 1 minute, 2 minutes, 5 minutes, or
Never.
• You may use your finger on the fader to set the delay time
• You may also use the Rotary Control to set the delay time
3.7.3 Meter Type
• Shows the current meter type that has been selected
• When touched, the pop up screen allows the quick change to a
different meter type on the main screen
• This is a redundant method of changing the meter type. You can
also engage this same Pop up screen by simply touch the meter
itself when the Meter page is active.
3.7.4 Analog VU Reference
You can calibrate the Analog meters to set the 0 VU level.
Using the fader on-screen or the Rotary Knob, the
0 VU mark on the meters can be calibrated between
-
3 dBFS and -24dBFS