H3C Technologies H3C S12500-X Series Switches - Manual (Page 220)

209
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter BGP-VPN instance
view. ip vpn-instance
vpn-instance-name
Configuration commands in
BGP-VPN instance view are the
same as those in BGP view. For
details, see Layer 3—IP Routing
Configuration Guide.
4. Configure the CE as the
VPN IBGP peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
created.
5. Create and enter BGP VPN
IPv6 unicast family view.
address-family ipv6 [ unicast ] N/A
6. Enable IPv6 unicast route
exchange with the specified
peer.
peer { group-name |
ipv6-address } enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
7. Configure the CE as a client
of the RR. peer { group-name |
ipv6-address } reflect-client
By default, no RR or RR client is
configured, and the PE does not
advertise routes learned from the
IBGP peer CE to other IBGP
peers, including VPNv6 IBGP
peers. The PE advertises routes
learned from the CE to other
IBGP peers only when you
configure the IBGP peer CE as a
client of the RR.
Configuring an RR does not
change the next hop of a route.
To change the next hop of a
route, configure an inbound
policy on the receiving side.
8. (Optional.) Enable route
reflection between clients.
reflect between-clients
By default, route reflection
between clients is enabled.
9. (Optional.) Configure the
cluster ID for the RR. reflector cluster-id { cluster-id |
ip-address }
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster,
use this command to configure
the same cluster ID for all RRs in
the cluster to avoid routing loops.
2. Configure the CE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Configure the PE as an IBGP
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
created.