H3C Technologies H3C S10500 Series Switches User Manual

Page 153

Advertising
background image

144

# Configure Switch A to work in preemptive mode, so that it can become the master whenever it works

normally; configure the preemption delay as five seconds to avoid frequent status switchover.

[SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5

# Set VLAN interface 3 on Switch A to be tracked, and configure the amount by which the priority value
decreases to be more than 10 (30 in this example), so that when VLAN-interface 3 fails, the priority of

Switch A in VRRP group 1 decreases to a value lower than 100 and thus Switch B can become the master.

[SwitchA-Vlan-interface2] vrrp vrid 1 track interface vlan-interface 3 reduced 30

2.

Configure Switch B

# Configure VLAN 2.

<SwitchB> system-view

[SwitchB] vlan 2

[SwitchB-vlan2] port gigabitethernet 1/0/5

[SwitchB-vlan2] quit

[SwitchB] interface vlan-interface 2

[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0

# Create a VRRP group 1 and set its virtual IP address to 202.38.160.111.

[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111

# Configure the authentication mode of the VRRP group as simple and authentication key as hello.

[SwitchB-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello

# Set the interval for master to send VRRP advertisement to four seconds.

[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 4

# Configure Switch B to work in preemptive mode, so that Switch B can become the master after the
priority of Switch A decreases to a value lower than 100. Configure the preemption delay as five seconds

to avoid frequent status switchover.

[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5

3.

Verify the configuration

After the configuration, Host B can be pinged successfully on Host A. To verify your configuration, use the

display vrrp verbose command.
# Display the detailed information of VRRP group 1 on Switch A.

[SwitchA-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Vlan-interface2

VRID : 1 Adver Timer : 4

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : Simple Key : hello

Virtual IP : 202.38.160.111

Virtual MAC : 0000-5e00-0101

Master IP : 202.38.160.1

VRRP Track Information:

Track Interface: Vlan3 State : Up Pri Reduced : 30

Advertising