H3C Technologies H3C S10500 Series Switches - Manual (Page 73)

64
To do… Use the command… Remarks
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as a
transit node of the primary ring,
and specify the primary port and
the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ]
level level-value
Required
Specify the current device as the
assistant-edge node of the subring,
and specify an edge port
ring ring-id node-mode
assistant-edge [ edge-port
interface-type interface-number ]
Required
Activating an RRPP domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the RRPP
domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do… Use the command… Remarks
Enter system view system-view —
Enable RRPP rrpp enable
Required
Disabled by default
Enter RRPP domain view rrpp domain domain-id —
Enable the specified RRPP ring ring ring-id enable
Required
Disabled by default
NOTE:
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring on
its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately:
• Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
• Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
Configuring RRPP timers
Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —