H3C Technologies H3C S7500E Series Switches - Manual (Page 83)

9-7
With QoS local ID marking, however, traffic limit applies to the two classes as a whole, allowing the
switch to dynamically assign the bandwidth to the two classes depending on their traffic size.
To configure QoS-local-ID marking to limit the total rate of the two classes, you need to mark packets
of the two classes with the same QoS-local-ID; create a class to match the QoS local ID, and associate
this class with the traffic policing action. The configuration procedure is as follows:
# Create ACL 2000 to match packets with source IP address 1.1.1.1.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 1.1.1.1 0
[Sysname-acl-basic-2000] quit
# Create a class class_a to match both packets with source MAC address 0001-0001-0001 and
packets with source IP 1.1.1.1.
<Sysname> system-view
[Sysname] traffic classifier class_a operator or
[Sysname-classifier-class_a] if-match source-mac 1-1-1
[Sysname-classifier-class_a] if-match acl 2000
[Sysname-classifier-class_a] quit
# Create a behavior behavior_a, and configure the action of marking packets with QoS-local-ID 100
for the behavior.
[Sysname] traffic behavior behavior_a
[Sysname-behavior-behavior_a] remark qos-local-id 100
[Sysname-behavior-behavior_a] quit
# Create a class class_b to match packets with QoS-local-ID 100.
[Sysname] traffic classifier class_b
[Sysname-classifier-class_b] if-match qos-local-id 100
[Sysname-classifier-class_b] quit
# Create a behavior behavior_b, and configure the action of limiting traffic rate to 128 kbps for the
behavior.
[Sysname] traffic behavior behavior_b
[Sysname-behavior-behavior_b] car cir 128
[Sysname-behavior-behavior_b] quit
# Create a QoS policy car_policy. In the QoS policy, associate class class_a with behavior
behavior_a, and associate class class_b with behavior behavior_b.
[Sysname] qos policy car_policy
[Sysname-qospolicy-car_policy] classifier class_a behavior behavior_a
[Sysname-qospolicy-car_policy] classifier class_b behavior behavior_b
Apply the QoS policy car_policy to the interface, and you can satisfy the network requirements.