Grass Valley K2 Media Client Service Manual Nov.18 2008 - Manual (Page 75)

July 28, 2008 K2 Media Client Service Manual 75
Restoring from the generic recovery disk image on E:
13. You are restoring both the C: partition and the D: partition, so select Yes, I want to
restore another partition or hard disk drive and then click Next .
The Partition or Disk to Restore page opens. Continue with the next step in this
procedure.
14. Select Database (D:) and then click Next .
The Restored Partition Location page opens.
15. Select Database (D:) and then click Next .
The Restored Partition Type page opens.
16. Leave the selection at Primary and then click Next .
The Restored Partition Size page opens.
17. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next .
The Next Selection page opens.
18. Select No, I do not and then click Next .
The Restore Operation option page opens.
19. Do not make any selections. Click Next .
The “…ready to proceed…” page opens.
20. Verify that you are restoring the correct partition or partitions. Click Proceed .
The Operation Progress page opens and displays progress.
21. When a “The data was successfully restored” message appears, click OK .
22. Click Operations | Exit to exit the Acronis True Image program.
The K2 Media Client restarts automatically.
23. Remove any CD currently in the CD drive while the K2 Media Client is shutting
down.
24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup
as follows:
a. Enter in Windows Product Key and click Next .
The Product Key is on a sticker on the right side of the K2 Media Client Chassis.
b. Enter the name of the K2 Media Client.
The factory default name is on a label near the power button.
The password is pre-set to the factory default. Leave the password as is.
c. Click Next
d. Set Time and click Next .
Windows loads network components and restarts the K2 Media Client.
Upon restart, a Found New Hardware wizard and/or messages about services/
drivers can be displayed.