Grass Valley K2 Media Client Service Manual Nov.18 2008 - Manual (Page 79)

July 28, 2008 K2 Media Client Service Manual 79
Installing the Fibre Channel card driver
• If the file is not present, procure the file from f tp://ftp.thomsongrassvalley.com/
pub/K2/Microcode_and _Drivers/LSI_SCSIPORT. The filename is
LSI_SCSIPORT_1.21.25.00.zip. Then continue with this procedure
2. After restoring the disk image and restarting the K2 Media Client, a Found New
Hardware wizard opens for the Fibre Channel controller. Install the driver on the
first FC port as follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select SCSI and Raid Controllers and Have Disk .
d. Browse to C:\profile\drivers\LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
3. If the K2 Media Client has a dual port Fibre Channel card, on the Found New
Hardware wizard, install the driver on the second FC port as follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select Have Disk .
d. Browse to C:\profile\drivers\LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
4. On the Found New Hardware wizard, install the first LSI Pseudo Device as
follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select Have Disk .
d. Browse to C:\profile\drivers\LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
5. If the K2 Media Client has a dual port Fibre Channel card, on the Found New
Hardware wizard, install the driver on the second LSI Pseudo Device port as
follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .