Grass Valley K2 Media Client Service Manual Nov.18 2008 - Manual (Page 83)

July 28, 2008 K2 Media Client Service Manual 83
Step 4: Identify problems using the startup sequence
3. Once the startup sequence begins, observe the progression of behaviors as listed in
the following table. These are the behaviors you should expect to see and/or hear
for a normally operating K2 Media Client. If you observe behaviors other than
those listed, refer to the indicated troubleshooting topics to identify problems.
NOTE: You can press the Pause/Break key on the keyboard to keep BIOS text on
the screen for longer viewing.
At about
this time…
This behavior should occur… If not, refer to the following:
— Pressing the standby button starts the K2 Media Client “Shutdown/restart problems” on page 87
0 seconds Power on LED goes on and stays on. “Power supply problems” on page 91
Service LED stays off.
Power supply LEDs go on (green) and stay on.
Chassis fan module and processor fan start “Thermal problems” on page 91
2 seconds CD LED flashes intermittently. This lasts for 5 - 10 seconds. “CD drive problems” on page 92
3 seconds On motherboard GigE ports, green LEDs go on, then off, then
on and stay on. This sequence lasts about 3 seconds. “Network, transfer, and streaming
problems” on page 101
18 seconds On NIC GigE ports, green and orange LEDs go on.
22 seconds Motherboard BIOS startup information appears, as
documented
page 85 .
“Motherboard/BIOS startup” on page 89
25 seconds On NIC GigE board ports, orange LEDs go off. Green LEDs
stay on. “Network, transfer, and streaming
problems” on page 101
SCSI controller adapter startup information appears, as
documented
page 86 .
“System problems” on page 97
62 seconds Motherboard BIOS startup summary screen appears, as
documented
page 87 .
“Motherboard/BIOS startup” on page 89
66 seconds Black screen appears. “Motherboard/BIOS startup” on page 89
71 seconds Windows starting up screen appears “Windows startup” on page 89
93 seconds Keyboard lights flash “Checking external equipment” on page 88
On all GigE ports, LEDs go off, then orange LEDs go on and
stay on while link activity LEDs begin pulsing, indicating
network traffic “Network, transfer, and streaming
problems” on page 101
94 seconds Black screen appears “Motherboard/BIOS startup” on page 89
109 seconds Blue screen appears “Windows startup” on page 89
113 seconds Windows logon screen appears. “Windows startup” on page 89
Logon to Windows to continue the startup sequence.
After Windows logon: