1 set u p – HEIDENHAIN IK 5000 Addendum User Manual
Page 87
Advertising
IK 5000 QUADRA-CHEK
87
2.1 Set
u
p
Scale factor for Open Loop joystick control
(Optional)
A CNC system can be operated in either Closed Loop or Open Loop
joystick control mode. This can cause a system to move with different
velocities when a user switches from one mode to the other. To make
the velocity comparable, a user can apply a scaling factor to the
joystick parameters when in open loop control mode. The Scale factor
ranges from 0.01 to 1.00. This is a unit-less value. The default value is
0.5.
Verify the system is set to Open Loop joystick control mode:
Click Tools>CNC...
Enter the Password
Click the General tab
Select the Set joystick control to Open Loop mode checkbox if
not already selected
Click OK
Set joystick control to Open Loop mode
Advertising