Yaskawa Varispeed-686SS5 CIMR-SSA - Manual (Page 42)

4 OPERATION
43
(a) Control Method Selection
The following procedures show how to change the control method from open loop vector
to flux vector.
Table 10 Control Method Selection/Change
Step Description Key Sequence Digital Operator Display
1 Power ON
• Displays speed reference value. G
REMOTE LEDs (SEQ, REF) ON
2 Control method selection
• Move to program mode.
DRIVE
PRGM
Constant No. display
3 • Move to control method selection
(A1-02). RESET
4 • Verify the set value.
DATA
ENTER
(Initial setting: open loop vector)
5 • Change to flux vector.
RESET
6 • Write-in the value.
DATA
ENTER
Displays for 0.5 seconds.
Setting completed.
7 Return to drive mode. DRIVE
PRGM G