RIGOL M300 - Manual (Page 115)

RIGOL
© 2007 RIGOL Technologies, Inc.
User’s Guide for DM3000 Series
3-11
Example 7: Reading Hold
Do these steps as follows:
1. Connect test leads as shown in Figure 1- 7.
2. Press button, select DC Voltage measurement function. Choose an
appropriate measurement range.
3. Set the Hold measurement function parameters.
(1). Press
 Auto  Hold  0.1%, set up the hold range to 0.1%.
Figure 3- 18 Hold Range Setting
(2). Press to save all changes, back to a higher level menu.
4. When the lights, press the button once, it will blink, which means the
trigger mode is now Hold mode. If current trigger mode is single, press the
button twice.
5. Lead test leads into circuit, start to measure.