RIGOL M300 - Manual (Page 120)

RIGOL
© 2007 RIGOL Technologies, Inc.
User’s Guide for DM3000 Series
4-4
To Change the Electric Power Fuse
The electric power fuse located in the rear of the Multimeter, the fuse is a kind of
delay, no-burst, 250V/300mAT, 5× 20mm one.
Operation steps
1. Disconnect the power. Use the tool to press down the block (as the dashed line
point out), and then pull out the seat of the fuse.
2. Choose the correct voltage shelves location in the voltage selected switches.
3. Enclose the seat of the fuse to the slot after placed the fuse.
Figure 4- 1
The sketch diagram of changing the fuse