RIGOL M300 - Manual (Page 98)

RIGOL
© 2007 RIGOL Technologies, Inc.
User’s Guide for DM3000 Series
2-50
Multi-Route Scanning
DM3054 and DM3064 have a built-in inspection Module with 16 channels for users to
perform Multi-Rote Scanning. The measured results could be easily checked or
analyzed under connecting with the PC software “Ultralogger”. (Refer to the
Standard accessories)
Connect the Inspection Box
Signals are inputted to the Multimeter through the Inspection Box. In order to
measure signals, please do the following steps:
1. Open the Inspection Box: remove the bolt and press down the two
mechanical-style slots on the surface to open it.
2. After open, you will see two rows of terminal and each row corresponds to 8
measurement channels. The name of input terminal and the number of channel
are marked near every terminal. (as CH01, LO and HI)
3. The channel from CH01 to CH12 in Inspection Box may be used to measure four
types of input signal that contains Voltage, 2-Wire Resistance, Capacitance and
Diodes, which that is the terminals in grey zone.
4. The channel from CH13 to CH16 in Inspection Box may be used to measure
Current, which that is the terminals in orange zone.
5. The terminal adopts Press mode for connection. First, press corresponding
button until the down-lead has been inserted into terminal, and then release so
as the down-lead could be hold down firmly.
6. After connecting the down-lead, tie up it by using the wire harness at the back
of the box.
7. Cover the Module and screw down.
8. Finally, insert the Inspection Box into the interface (Differential Multiplexer
Interface) on the rear panel of DM3000 shown in the following figure: