Charging the batteries – Sony AG-R2 Attachment Grip User Manual
Page 32
Airpeak S1
ARS-S1
Charging the batteries
Before using this product, charge the aircraft battery packs and built-in remote controller battery.
Charging the aircraft battery packs
To check the battery level
You can check the battery level by pressing the battery level button on each battery pack (
).
Note
It may take about 20 seconds before charging begins. Wait until the battery level LEDs start flashing.
A safety mechanism prevents charging when battery packs are hot or cold. Charging begins automatically once battery packs
can be charged at room temperature.
If the difference between the remaining battery level in the two battery packs is 20% or more, the aircraft motor will not start.
Charging the built-in remote controller battery
Connect the power cord (
) to the AC adapter for battery charger (
).
1.
Connect the AC adapter to the power port (
) of the battery charger.
2.
Place the battery packs in the battery charger.
The battery charger can hold two battery packs and will charge the second one after the first one is charged. Both
cannot be charged at the same time.
3.
Firmly insert the plug of the power cord (
) into the wall outlet.
The battery level LEDs of the battery pack (
) flash during charging and go off when the battery pack is fully
charged.
4.
32