Handler out chk, Handler paused, Exatron 3000b – Extron electronic 3000B User Manual
Page 109
Exatron 3000B
www.exatron.com
6-8
Chapter 6 Display Dictionary
HANDLER OUT CHK
Please refer to the Diagnostics/INTERFACE CHECK: Output Port Check (Output Cover LED Check)
section in Chapter 5 of this manual for details.
HANDLER PAUSED
You have pressed the [PAUSE] button. The handler is now in a wait loop. Nothing will occur until you
press one or more of the handler controller’s buttons.
W
HILE THE HANDLER IS IN
P
AUSE
M
ODE
,
YOU MAY MAKE THE FOLLOWING FUNCTION CHANGES IN ANY ORDER
:
PLUNGE DEPTH (Plunge-to-board change kits.)
Press the [2] key. Display will read, PLUNGE = _____.
(The current plunge depth setting
will be shown.)
Enter desired plunge depth changes using the controller keypad number keys. The handler
allows changes to each digit from lowest to highest in order. First enter Ones, then Tens,
then Hundreds, then Thousands. For example: to enter a plunge depth of 625, press [5],
then [2], then [6], then [0]. The display will read: 0625.
Press the
Enter
button to return to
HANDLER PAUSED
message.
STOP ON FAIL
Press the
[3]
key. Display will read,
STOP ON FAIL ?
Answer Yes by pressing the
[1]
key.
Answer No by pressing the
[2]
key
Press the [
Enter]
button to return to
HANDLER PAUSED
message.
PICK INTERFACE
Press the
[4]
key. Display will read,
PICK INTERFACE ?
Select
HANDLER PORT
by pressing the
[1]
key.
Select
EXATRON SUPER
by pressing the
[2]
key.
Select
PROGRAM RS-232
by pressing the
[4]
key.
Select
EXATRON RS-232
by pressing the
[5]
key.
Press the [
Enter]
button to return to
HANDLER PAUSED
message.
PICK PACKAGE
Press the
[5]
key. Display will read,
PICK PACKAGE ?
Select
RUN PLCC PLUNGE
by pressing the
[1]
key.
Select
RUN DIPS PLUNGE
by pressing the
[2]
key.
Select
RUN SOIC PLUNGE
by pressing the [
3]
key.
Select
RUN AIR PLUNGER
by pressing the
[4]
key.
Select
PLCC SWING HEAD
by pressing the
[5]
key.
Select
RUN DIPS - 2800
by pressing the
[6]
key.
Select
RUN TYPE3 SOIC
by pressing the
[7]
key.
Select
RUN SOT
by pressing the
[8]
key.
Press the [
Enter]
button to return to
HANDLER PAUSED
.
message.