Extron electronic 3000B - Manual (Page 8)

Exatron 3000B
www.exatron.com 1-2 Chapter 1 Introduction
The handler may be operated in either of two modes: AUTO or MANUAL. MANUAL operation allows for
Handler Diagnostics sequences to be run, Handler Set-Up changes to be entered, and mechanical
adjustments to be made at the operator's convenience before, during, and after automatic Handler
operation.
AUTO operation continuously cycles devices through the handler. The handler will stop when empty but
re-start automatically when more devices are loaded. Each output tube may be filled to any pre-set
amount, with individual counters keeping track of quantities in all outputs. When an output tube fills, the
handler automatically begins to fill any other unfilled tube assigned to the sort signal received from the
tester. When all output tubes are filled, the handler will stop and a message will be displayed, such as,
ALL OUTPUTS FULL. The tube counter is automatically reset by removing the full tube and re-inserting
an empty tube. The handler will not cycle devices to outputs which have no tubes or which are full.
Additionally, a continuous subtotal count is maintained for each output, up to a total of 999,999 devices.
Sorting is accomplished by use of a stepper motor and a solenoid released shuttle. Dual positive binning
sensors keep track of the shuttle's position at all times. In the event of a sorting problem, a message will
be displayed on the handler's front panel, and the device will not be binned until the problem is corrected.
The Model 3000B Handler, like all E
XATRON handlers, is guaranteed to properly bin every device even
during "power down" conditions. E XATRON has been one of the pioneers in the area of positive binning
functions. E XATRON test handling equipment meets or exceeds the standards set by M OTOROLA "Six
Sigma" binning requirements.
Model 3000B Handlers may be configured for all of the following packages:
-DIP, Dual In-Line Packages: "Live Bug" or "Dead Bug" 0.300", 0.400", 0.600", 0.900" Body Width,
8 to 48 Pins, Standard Range
4 to 64 Pins, Optional Range
0.070" or 0.100" Pitch Leads
-SOIC, Small Outline Integrated Circuits: "Live Bug" or "Dead Bug" 0.150",
-SOJ,"J" Lead Shape: 0.170", 0.210", 0.300", 0.330", 0.350", 0.450" Body Width;
0.100", 0.079", 0.050", 0.039", 0.025", 0.020" Pitch Leads
-PLCC, Plastic, Leaded Chip Carriers: 18, 20, 24, 28, 32, 44, 52, 68, 84 Pin PLCCs, "Live Bug" only.
-LCC, Leadless Chip Carriers: 18, 20, 24, 28, 32, 44, 52, 68, 84 Pad LCCs, "Live Bug" only.
-SIP; SIL, Single In-Line Packages: D-Pak, D2-Pak, D3-Pak, TO-218, TO-220, TO-247, TO-3P,
TO-3PBL, DO-214, SOT23
Custom Hybrid SIPs, Others
-TSSOP
-Small Printed Circuit Boards
- ZIP, Staggered Lead Form Single In-Line Package
-SIMM, Single In-Line Memory Modules
-Other Memory Modules
-Numerous Custom Devices