Extron electronic 3000B - Manual (Page 32)

Exatron 3000B
www.exatron.com 2-6 Chapter 2 Installation
Please refer to Figure C.
3. Locate the two plate hanger blocks (#3000-037.)
4. Using two #1/4 x 20 x1.50" long bolts and two lock washers, mount the plate hanger blocks
onto the frame, threaded end up. These holes are marked "G" on FRED detail Figure C. Do
not tighten the bolts yet.
5. Remove the handler main plate (#3000-301) from the base plate (#3000-216). Remove the
hinges and the tilt blocks.
6. Using two #1/4 x 20 x .62" long bolts and two lock washers, bolt the handler to the plate
hanger blocks on the frame through the holes marked "G" on FRED detail Figure C.
7. Using four #1/4 x 20 x 1.37" long bolts and four lock washers, bolt the handler main plate to
the frame through the four tapped holes on the main plate also used by the base plate hinges.
These holes are marked "E" on FRED detail Figure C.
8. Verify that the slide angle and handler height are correct for your application then, tighten all
bolts on the frame, risers, rigid support bars and uprights.
9. TRAY OPTION: Using three #1/4 x 20 x 2.50" long bolts, three lock washers and three #1/4 x
20 hex nuts, bolt the tray extension frame to the bottom edge of the FRED frame. Tighten all
three bolts.
DETAIL C