Extron electronic 3000B - Manual (Page 70)

Exatron 3000B
www.exatron.com 4-4 Chapter 4 Handler Setup
Enter changes to the plunge depth using the controller keypad number keys. The
handler allows changes to each digit from lowest to highest in order. First enter
Ones, then Tens, then Hundreds, then Thousands. For example: to enter a plunge
depth of 625 steps, press 5, then 2, then 6, then 0. The display will read: 0625.
[-] The minus key will set the count to 0000.
[Enter] = Sets your selection.
[Clear] = Resets to the top of the handler's PLUNGE = XXXX loop.
E.
The handler will now display FULL TUBE = 0045. (Or some other four-digit number.)
This is the number of devices the handler will place into each of the handler's output
tubes. Be careful not to set the count for more parts than will fit into the handler's
output tubes.
Enter changes to the full tube count using the controller keypad number keys. The
handler allows changes to each digit from lowest to highest in order. First enter
Ones, then Tens, then Hundreds, then Thousands.
For example: to enter a full tube count of 25 devices, press 5, then 2, then 0, then 0.
The display will read: 0025.
[-] The minus key will set the count to 0000.
[Enter] = Sets your selection.
[Clear] = Resets to the top of the handler's FULL TUBE = XXXX loop.
8.
After making your selection, press the [Enter] button to display SELF ADJUST Z if your
changeover kit is Plunge to Board Style, or READY TO RUN if your changeover kit is not
Plunge to Board.
Load devices into any or all of the octoloader's eight input slots.
Press the [RUN] button to begin testing/programming if your changeover kit is not Plunge to
Board Style.
9.
If your changeover kit is Plunge to Board Style, press the [RUN] button. The handler will now
run the Automatic Z Adjust Cycle as described in Chapter 5, Diagnostics. When this
procedure is finished, the Z plunger top position will be adjusted to accommodate the devices
to be run and the sample device used will be flushed to output bin 5.
10.
Press the[Clear] button to exit SELF ADJUST Z.
The handler will now display READY TO RUN.
Press the [RUN] button to begin testing/programming.