Fluke 5020A - Manual (Page 113)

Digital Communications Interface
Commands
6
6-43
Caution
If the password is forgotten, the themo-hygrometer must be
returned to an Authorized Service Center to have the password
restored.
SYSTem:PASSword:RECord?
Returns the state of data recording settings password-protection.
Example: SYST:PASS:REC?
Response: 0
A value of 1 is returned if data recording password settings are password-protected;
otherwise a value of 0 is returned.
SYSTem:PASSword:RECord <bool>
Sets the state of data recording settings password-protection.
Example: SYST:PASS:REC 1
The <bool> parameter turns the data recording password-protecton on (1 or ON) or off (0
or OFF). This command is password protected. Commands protected with this setting
are: DATA:REC:CLE, DATA:REC:FEED:RHUM, DATA:REC:FEED:TEMP, and
DATA:REC:TIM.
SYSTem:PASSword:SENSor?
Returns the state of the sensor settings password-protection.
Example: SYST:PASS:SENS?
Response: 0
A value of 1 is returned if the sensor settings password-protection is enabled. Otherwise,
a value of 0 is returned.
SYSTem:PASSword:SENSor <bool>
Sets the state of the sensor settings password-protection.
Example: SYST:PASS:SENS 1
The <bool> parameter turns the sensor settings password-protection on (1 or ON) or off
(0 or OFF). This command is password protected. Commands protected with this setting
are: CALC:PAR:DATE:TIME, CALC:PAR:RES, ROUT:CLOS, ROUT:OPEN,
SENS:AVER, SENS:IDEN, SENS:LOCK,and TRIG:TIME.
SYSTem:PASSword:STATistics?
Returns the state of the statistics settings password-protection.
Example: SYST:PASS:STAT?
Response: 0
A value of 1 is returned if the statistics settings password-protection is enabled,
otherwise, a value of 0 is returned.
SYSTem:PASSword:STATistics <bool>
Sets the state of the statistics settings password-protection.