Finisar Surveyor - Manual (Page 160)

7-24
Surveyor
User’s Guide
The steps used to create the filter template and load it to a resource are shown
below:
1. Press the
Clear Template button.
2. Press the Name button for Station Address 1 . Select the address from the
name table and click OK .
3. Press the Name button for Station Address 2 . Select the address from the
name table and click OK .
4. Pull down the Direction box and set the indicator to bi-directional (<->).
5. Be sure the Apply Conversation to Template check box is selected in the Add
Conversation to Filter Template area.
6. Press the Save Custom Template button.
7. Enter the name of the new filter template in the Add to Available Filter
Templates dialog box. The name in the example is
Station_7and_8_Conversation . The new filter template name appears in the
Custom_Templates
section of the Available Filter Templates box.
8. Press the Add button to apply the filter template. The filter template appears in
the Template Combination box.
9. Press the Load Filter button to load the filter to the resource.
10. You are now ready to start capture. The capture buffer will contain only the
packets that match the filter criteria. The filter criteria includes the templates
shown in the
Template Combination box and the packet types selected in the
lower portion of the FILTER CREATION box.