Finisar Surveyor User Manual
Page 38
2-8
Surveyor
User’s Guide
5. To update the device driver, click with the right mouse on
My Network Places
.
Select
Properties
from the menu.
6. Double-click on
Local Area Connection
. The Racore device driver should
appear in the
Connect
box.
7. Press
Configure
and then select the
Device Driver
tab.
8. Press
Update Driver...
. The
Upgrade Device Driver Wizard
displays. Click the
Next
button to continue.
9. Select the
Display a list of the known device....
radio button and then click
Next
.
10. Click the
Have Disk...
button. The
Install from Disk
window appears.
11. Insert the Surveyor CD in the CDROM drive.
12. Use the
Browse...
button to find the Ethernet Driver (
<CDROM-drive-
letter>\drivers
) directory on the Surveyor CDROM and click
OK
.
13. The
Update Device Driver
window will appear. Select the “Finisar 10/100
Ethernet Analyzer Plug_Play” driver. Click the
Next
button.
14. Click the
Next
button again when the next window appears. The system will
display the
Digital Signature Not Found
dialog box. Click
Yes
. (Note: You can
safely ignore the warning message. The message appears because Windows
2000 does not recognize the card properly at this time.)
15. The Finisar driver will be copied to the hard drive. Windows 2000/XP may
request the Windows CDROM to install system files. Many of these system
files can be found directly on the hard drive in the
C:\windows\system
and
C:\windows
directory without using the CDROM.
16. To verify that the analyzer card is properly installed, open the
System
folder in
the
Control Panel
. Go to the
Hardware
tab in the
System Properties
window.
Select the
Device Manager
. If no error marks exist through the
Network
icon, the
installation is complete. If an error exists, highlight the problem adapter and
press the
Remove
button. Reboot the notebook computer and attempt the
installation again. If the problem persists, contact Technical Support.
17. Reboot your system.
Installing More Than One Analyzer Card in a Notebook PC
If you are installing two Portable Surveyor 10/100 Ethernet Analyzer Cards, install
one card, make sure it works within Surveyor, and then install the second card.