Genicom MatrixPrinter LA36 User Manual
Page 59
Advertising
4-23
(11) Space motor (SP motor) assembly replacement
Removal
1.
Remove the printing mechanism (Section 4.9.1 (5)).
2.
Remove the two screws to remove the space motor.
3.
Detach the carriage drive belt from the motor drive pulley, then remove the space motor.
4.
Remove the motor cable from the cable clamp.
5.
Disconnect the cable connector from the space motor.
Motor drive pulley
Space motor
Cable connector
Installation
Install the space motor assembly in reverse order of removal.
Make sure that the motor cable entrance is oriented toward the bottom and inside the printer as shown below.
Side frame
Bottom
Advertising