Genicom MatrixPrinter LA36 - Manual (Page 69)

4-33
7. Move the carriage unit to the left-end print position (column 1).
8. Turn adjustment lever L at the left end of the stay shaft and adjust it so that the gap is 0.38 ± 0.03 mm.
Adjustment lever L
Paper thickness lever
Adjustment lever R
Right-side frame
11. Move the carriage unit to the center and check the gap. If the gap does not satisfy the value, return to step 8.
12. Move the carriage unit again to the left, center, and right to confirm the gap. If the gap does not satisfy the
value, return to step 8.
Left-side frame
9. Move the carriage unit to the furthest right printing position.
10. Turn adjustment lever R at the right end of the stay shaft and adjust it so that the gap is 0.38 ± 0.03 mm.