Melsec-q, 5 data used for positioning control, 1) absolute (abs) system, current value changing – MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D User Manual

Page 150

Advertising
background image

5 - 62

MELSEC-Q

5 DATA USED FOR POSITIONING CONTROL

Da.4 Deceleration time No.

Set which of "deceleration time 0 to 3" to use for the deceleration time during
positioning.

0 : Use the value set in "

Pr.10

Deceleration time 0".

1 : Use the value set in "

Pr.28

Deceleration time 1".

2 : Use the value set in "

Pr.29

Deceleration time 2".

3 : Use the value set in "

Pr.30

Deceleration time 3".

Da.5 Axis to be interpolated

Set the target axis (partner axis) for operations under the 2-axis interpolation
control.
0 : Selects the axis 1 as the target axis (partner axis).
1 : Selects the axis 2 as the target axis (partner axis).
2 : Selects the axis 3 as the target axis (partner axis).
3 : Selects the axis 4 as the target axis (partner axis).
Note)

•

Do not specify the own axis number or any number except the above.
(If you do, the "Illegal interpolation description command error" will
occur during the program execution (error code: 521).)

•

This item does not need to be set in case 3 or 4-axis interpolation is
selected.

Setting value, setting range

Setting value buffer memory

address

Item

Value set with peripheral device

Value set with sequence

program

Default

value

Axis 1 Axis 2 Axis 3 Axis 4

Da.6

Positioning address/
movement amount

The setting value range differs according to the "

Da.2

Control

system".
Here, the value within the following range of [Table 1] range is set.

[Table 1] on right page

0

2006
2007

8006
8007

14006
14007

20006
20007

Da.6 Positioning address/movement amount

Set the address to be used as the target value for positioning control.

The setting value range differs according to the " Da.2 Control system".

((1) to (4))

(1) Absolute (ABS) system, current value changing

•

The setting value (positioning address) for the ABS system and current value

changing is set with an absolute address (address from OP).

-1000

3000

1000

Stop position
(positioning start address)

Movement
amount : 2000

Movement
amount : 2000

Advertising