MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 551)

12 - 75
MELSEC-Q
12 CONTROL SUB FUNCTIONS
[5] Teaching program example
The following shows a sequence program example for setting (writing) the
positioning data obtained with the teaching function to the QD75.
(1) Setting conditions
•
When setting the current feed value as the positioning address, write it
when the BUSY signal is OFF.
(2) Program example
• The following example shows a program to carry out the teaching of axis
1 by the dedicated instruction "TEACH 1".
1) Move the workpiece to the target position using a JOG operation (or
an inching operation, a manual pulse generator operation).
PLC READY signal
QD75 READY signal
V
t
Forward run JOG start signal
Target position
BUSY signal
[X8]
n2 n1 nx Md.20 Current feed value
Example
Error detection signal
[XC]
[X0]
[Y0]
[Y8]