MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 233)

6 - 13
MELSEC-Q
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
Continued from previous page
No.7
Positioning start No.
setting program
No.10
JOG operation program
No.13
Manual pulse generator
operation program
No.8
Positioning start program
No.9
M code OFF program
Refer to Section 6.5.2
Refer to Section 6.5.3
Refer to Section 11.2.4
Refer to Section 11.4.4
Program to reset the start
signal and turn the M code
ON signal OFF
Start details setting program
Start program
JOG operation program
Manual pulse generator
operation program
Continued on next page
No.12
No.11
Inching operation program Refer to Section 11.3.4
Inching operation program
No.12
Program required to carry out
• "OPR control"
• "Major positioning control"
• "High-level positioning control"
Program required to carry out
"manual control"