Intermec 700 - Manual (Page 413)

Configurable Settings Appendix — A
389 700 Series Color Mobile Computer User’s Manual
LEAP (Cisco Lightweight EAP)
LEAP is the Cisco Lightweight version of EAP. See page 371 for informa-
tion about EAP.
Use “LEAP” to configure the use of LEAP as an authentication protocol,
select “Open,” “WPA,” or “Network EAP” as an association mode, or as-
sign Network EAP. Note that this defaults to the Network EAP.
To Enable LEAP with an Open Association
1 Set 8021x Security as “LEAP.”
2 Set Association to “Open.”
3 Skip Encryption as it is automatically set to “WEP.” See page 372 for
information about WEP encryption.
4 Enter your unique User Name to use this protocol.
5 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
to automatically use the protocol without entering a password.