Intermec 700 - Manual (Page 43)

Introduction — Chapter 1
19 700 Series Color Mobile Computer User’s Manual
Resetting Your 700 Color Computer
Performing a Warm-Boot
Performing a warm-boot may be necessary to correct conditions where an
application stops responding to the system. It does, however, unload all
running programs.
Press and hold the I/O key for about ten seconds, then the 700 Color
Computer continues from the screen you were at before you performed
the warm-boot.
Performing a Cold-Boot
In some cases where the 700 Color Computer completely stops respond-
ing, it may be necessary to perform a cold-boot. Because this may result in
data loss, this procedure is not recommended unless all other recovery
methods have failed.
Note: This deletes all programs and data stored in RAM including the Ob-
ject Store. Make sure data is backed up to your host computer or a storage
card before performing a cold-boot.
1 Release the lower clip of the hand strap.
2 Remove the battery pack.
3 Press the Reset button.
4 Reinstall the battery pack.
Reset button Reset button
700 Color Computer 730 Computer
This illustration shows the back of the 700 Color Computer on the left and of the 730 Computer on the right.