Intermec 700 - Manual (Page 426)

Troubleshooting Appendix — B
402 700 Series Color Mobile Computer User’s Manual
The 700 Color Computer does not respond when connected to a power supply.
Make sure your ac adapter or dock is plugged in and is making good con-
tact with your mobile computer.
The 700 Color Computer will not turn on when the I/O key is pressed.
The battery may be low and need recharging.
The Power status LED starts blinking.
The Power status LED provides the status of your battery pack when it is
connected to a charging device. See Chapter 1, “Introduction,” for LED
descriptions.
The 700 Color Computer will not turn on and the screen is blank.
The battery may be critically low. Put your mobile computer in a charger
for at least five minutes, remove it from the dock, then press the I/O but-
ton. The screen should turn on.
Put your mobile computer back in the charger and continue to charge
your mobile computer for at least four hours to make sure the battery is
fully charged.
The 700 Color Computer will not turn on when placed in a dock.
Make sure the dock is plugged in and your mobile computer is securely
seated in the dock.
The 700 Color Computer shuts down during operation.
You may have a very low battery. Put the battery in a charger.
The 700 Color Computer does not turn off.
The 700 Color Computer does not turn off while it is processing data. If
this situation continues for a long period of time, it does run down the
battery unless you have it connected to an external power, or in a charging
dock.
Should the 700 Color Computer lock up, perform a warm-boot. If the
mobile computer stays locked up, then perform a cold-boot. See Chapter
1, “Introduction,” for information on performing warm-boots and cold-
boots.
The 700 Color Computer takes a long time to boot up after a warm- or cold-boot
is performed.
Normal recovery time is 30 to 45 seconds. If the recovery takes longer,
then contact support personnel.