Initio INI-9100UW - Manual (Page 107)

12-3
Question: Under SCO UnixWare, the system displays a panic message or
crashes during bootup:
Answer: Reboot the system and verify that the INI-9100U/9100UW is
using IRQ10. Please Refer to your system documentation to set the
interrupt levels and your peripheral documentation for help in setting
SCSI ID’s.
In order to boot from the old UnixWare kernel, reboot the system and
execute the following steps:
• •
Begin an interactive boot session by pressing the
<SPACEBAR> at the BOOTING UNIXWARE prompt.
• •
At the system [boot]# prompt, type KERNEL=unix.org
<ENTER>
• •
Type go <ENTER>.
•
Consult the SCO UnixWare Installation Handbook
“Troubleshooting” section to help isolate the problem. If it
becomes necessary to remove the Initio device driver, please
consult the “Removing the Initio Driver from a SCO
UnixWare System” section of this document.