Installation in ten easy steps – Initio INI-9100UW User Manual

Page 31

Advertising
background image

3-4

INI-9100U

INI-9100UW

Description

J1

J1

50-pin Internal Ultra SCSI Connector

J4

68-pin Internal Ultra Wide SCSI Connector

J2

50-pin External Ultra SCSI Connector

J2

68-pin External Ultra Wide SCSI Connector

JP1

JP1

Active Termination Jumper for Multiple
Initiators

J3

J3

External Drive Activity LED Connector

table 3-1 Component Description

To increase the reliability of the cabling being used with the INI-
9100U/9100UW, it is recommended that the following guidelines be observed:

Synchronous SCSI - up to 6 meters or 20 ft

Fast SCSI - up to 3 meters or 10 ft

Ultra SCSI - 4 devices, up to 3 meters or 10 ft

UltraWide SCSI - 4 devices, up to 3 meters or 10 ft

Ultra SCSI - 7 devices, up to 1.2 meters or 4 ft

UltraWide SCSI - 8 devices, up to 1.2 meters or 4 ft

Use high quality twisted pair cable.

Impedance of the cable should be between 90-110 ohms.

Use high quality shielded connectors.

Installation in ten easy steps

The following steps will guide you through the installation of the INI-
9100U/9100UW host adapter into the host system. The host adapters are
designed to be inserted into a PCI bus compliant host computer system. If you
are an experienced installer and have installed this product according to the
“Quick Installation Guide” then skip to Chapter 4.

1. Power down the host computer and all peripherals.

Remove the cover from the host system. You may need to refer to the
system manual for cover removal. If necessary, identify the PCI
sockets inside the host system with the aid of the system
documentation.

Advertising
This manual is related to the following products: